Scales is a device used in technological lines on the hopper of SD dryer , cooler SD .
The contaminated material enters the WAG via an inlet located under the WAG chamber (drawings opposite). The material under the influence of gravity slides down the floor of the shutter, which has embossed small holes to let air pass through. Forced air from the fan inlet towards the fan outlet pulls out small and light dirt, dust and chaff from the sliding material of the shutter floor. WAG is a device that does not require constant service, supervision over its work is entrusted to an employee supervising part or all of the technological line. During the operation of the windmill, attention should be paid to the correct and relatively even air flow.
Air outlet with fine impurities
Drive unit for the fan impeller
Grain inlet into the WAG chamber
Floor on which grains are poured
There are special embossings in the floor through which air drawn in by the fan penetrates. The air flow from the fan is strong enough to carry away small impurities
Duct for intake air
An inlet that allows air to move freely inside the WAG
Outlet of WAG pre-cleaned fine grains
WAG outlet and fan inlet
The fan draws air with small impurities through the entire WAG chamber and ejects it into the cyclist, for example
Sight glass for visual assessment of WAG work
Sight glasses are located on both sides of the WAG p>
One of WAG's alloys
There are four feet in WAG this is standard equipment. It may change depending on how the WAG is installed
The fan has mechanical air force regulation
Inside the fan there is a plate choking the amount of air fed. It can be fully open or gradually the gap can be reduced
Welcome to the gallery of objects