The PSK Screw Conveyor has a capacity of 20 [t / h] (PSK200 / 20) and 40 [t / h] (PSK200 / 40) is the most often required and occurring device when moving material over short distances. Pipe screw conveyors of the PSR200 / 20 and PSK200 / 40 series intended for grain transport have a modular structure, enabling easy configuration of the device depending on the user's needs. Our offer includes PSK conveyors from 2m to 10m in length.

Recommended horizontal work position. It is possible to mount our devices at an angle ranging from 0st to 30st. Depending on the angle, the nominal capacity of the device decreases (using the same drive). The innovative solution is lining the pipe from the inside with PE-UHMW material with reduced friction coefficient.

This solution has the following advantages:

- facilitates the movement of transported material, which significantly reduces the wear of conveyor components having direct contact with the transported material
- reduces the power demand for conveyor drive,
- reduces damage to transported grains,
- noise resulting from grain movement is reduced.

We encourage you to contact us by phone or e-mail regarding PSK conveyors. We provide advice in the selection and configuration of an assortment. Our experts will explain all technical matters related to AG-PROJEKT products.

Model PSK

Gearmotor

Main drive

The appropriate gearmotor model is selected for the ordered PSK model
Geared motor

Overflow flap

Lack of material collection from the worm-conveyor belt during operation will raise the flap of the device and open the limit switch.

This disables the device.

This is standard equipment, other safeguards are optional.

Initial bearing

The first bearing from the gear motor drive side mounted on the PSK housing

Discharge element

Element responsible for spilling material from the PSK conveyor.
Depending on the model and its parameters, the discharge element may have a different diameter adapted to the technological lines.

Sampling hatch

Element used for pouring material for humidity measurement. Pulling the manhole out will cause grains to spill out. After cooling, the grain can be subjected to moisture measurement control

Scroll module

Screw assembly with rollers.
Shafts enter the bearing openings and the gear motor drive.

PE-UHMW

Hard-wearing PE-UHMW

The use of wear-resistant plastic extends the life of the conveyor troughs and reduces the consumption of electricity.
PE-UHMW

Trough connector with support

Element connecting troughs in PSK. Standard element for connecting pipe troughs to each other.

Conveyor charge

Filling PSK can be installed anywhere on the cover. Depending on the model and its parameters, the charging element may have a different diameter adapted to technological lines.

Insteje possibility to mount several hoppers in PSK

Rear end bearing

End bearing element closing the drive system. Attached to the end of the PSK case